
latest
2009 Corvette Z06
TREATMENT
- Wash & Decontamination
- Multi-Stage Paint Correction
- Opti-Coat Paint Protection
DESCRIPTION
Not too many of these in the country, this is the C6 Z06 model with a 505hp 7lt (427ci) LS7 V8. It is a lighter version of the standard C6, using aluminium instead of steel for its frame construction.
Back to Gallery
Here is the car as presented

It only had a little under 4500km on the clock, but there was still much room for improvement as we will see.

The wheels had large amounts or tar build up in all four barrels

Three rounds of tar remover for each wheel and agitation with a toothbrush ended up getting it

Tar remover working away. I think this was the second or third round

Cleared out


There was also tar splatter up both sides of the car. Not big clumps, just lots of small dots here and there along the length


Citrus degreaser was used to break them down quite effectively

Gone
">
Gunk also stuck in the embossed "Corvette" on the rear bumper

Being removed with citrus degreaser and a cotton bud

The engine bay also got a wipe down and dressing Before


After


Paint inspection and polishing Though the swirling was largely only moderate, the challenge here was the paint hardness. A three stage correction spanning around 13hrs was required to achieve acceptable results Before

After

Before

After

Before

After

Before

After

Before

After

Before

After

Before

After


Bonnet Before

After

Before


After


The headlights had paint protection film over them which was also swirled up

After. The protection film still had some minor haze as a result of the film itself

As the wheels were chrome, wheel acids were out of the question. Hand polishing was required to clean off some of the hard residue that the wash/decon didn't shift. Before. Lots of baked on residue


After hand polishing




The mud guards on the front wheel arches were very badly faded. A trim restorer was able to somewhat restore them Before

After. Not perfect but a definite improvement

A trim restorer was also used to good effect on the rear lower bumper valance

Final shots. Raining unfortunately, so only garage pics







